Hammerhead SWITCH HHS1200 Manual De Instrucciones página 15

OPERATING INsTRUCTIONs
9. Hammering Nails
a. Set the function switches to auto
hammering mode marked with
" " .
b. attach the auto hammer adaptor
to the tool.
c. Position the direction-of-rotation
selector to either the right or the
left.
d. Secure the material to be nailed
with clamps to keep it from turn-
ing when hammering.
e. Insert the head of the nail into the
adaptor so that it contacts the
recessed shaft. Place the tip of the
nail against the workpiece.

WARNING: before depressing the trigger switch to start hammering, make sure that
the adaptor is securely attached on the tool. Otherwise, the adaptor would move, causing
serious personal injury.
f. Holding the shaft of the nail steady with your hand, push down on the tool and press
the trigger switch to initiate the hammering action, and drive the nail just far enough
into the workpiece so that it will stand on its own. release trigger switch and
remove your hand from the nail.

CAUTION: be especially careful when driving shorter nails, such as brads, that you
remove your hand as soon as the nail stands on its own in the workpiece.
g. resume pushing down on the tool and pressing the trigger switch to continue
hammering until the nail is fully driven into the workpiece. Near the end of ham-
mering, the adaptor will retract to allow the hammerhead to drive the nail head
flush to the workpiece.

WARNING: To avoid possible serious injury, do not exert excessive force on the tool
or apply side pressure. Hold the tool firmly while pushing steadily to allow the hammerhead
to drive the nail automatically.
SWITCH™_12V rIgHT aNgLE IMPaCT DrIVEr – auTO HaMMEr
9
15