Hammerhead SWITCH HHS1200 Manual De Instrucciones página 14

OPERATING INsTRUCTIONs
8. Tightening and Loosening
screws and Nuts
a. Set the function switch to impact
driving mode, marked with "
b. Install the correct bit.
c. Position the direction-of-rotation
selector to the proper direction.
d. Apply just enough pressure to
keep the bit engaged on the screw
or nut.
e. apply minimal pressure to the
trigger switch initially. Increase
the speed only when you can
maintain full control.

WARNING: Do not over-tighten, as the force of the impact driver can break the
fastener. Keep the Impact driver at a right angle to the fastener to avoid damaging the
fastener head.

WARNING: after operating, the tool should be placed horizontally on a surface, do not
attempt to stand it upright..
NOTICE: This tool can also be used for drilling in wood with suitable drilling bits when the
function switch is set to drive mode. for maximum performance, never use this tool for
drilling in metal or masonry.
14
8
" .
SWITCH™_12V rIgHT aNgLE IMPaCT DrIVEr – auTO HaMMEr