Hammerhead SWITCH HHS1200 Manual De Instrucciones página 13

OPERATING INsTRUCTIONs
6. Auto Hammer Adaptor
The auto hammer adapter permits the
tool to be used in the auto hammer
function.
When not in use, the auto hammer
adaptor provided with the tool can
be placed in the storage area lo-
cated on the base of the tool. Store
the adaptor on the base of the tool
by snapping it into place.
7. Installing bits /
Auto Hammer Adaptor
a. Lock the trigger switch by placing
the direction-of-rotation selector
in the LOCKED (center) position.
b. With one hand, pull the sleeve
toward the front of the tool and
hold it in place.
c. With the other hand, insert a 1/4"
bit or the auto hammer adaptor
into the hexagonal opening in the
bit retainer.
d. release the sleeve and check that
it returns to its original position.

WARNING: If the sleeve does not return to its original position, the bit or adaptor
is not correctly installed. retry until the bit or adaptor is properly installed and the sleeve
returns to its original position.
Removing bits /Auto Hammer Adaptor
a. Lock the trigger switch by placing the direction-of rotation selector in the LOCKED
(center) position.
b. Pull the sleeve towards the front of the tool and hold it in place.
c. remove the bit or adaptor from the hexagonal opening in the bit retainer.
d. release the sleeve.

WARNING: The bit may be hot after prolonged use. use protective gloves when
removing the bit or adaptor from the tool, or first allow the bit to cool down.
SWITCH™_12V rIgHT aNgLE IMPaCT DrIVEr – auTO HaMMEr
6
7
13