Seat Height - Dauphin Permanent-Contact+Tension Manual De Instrucciones

F
u n c t i o n

Seat height

Sit right back in the chair and raise lever to adjust height
Adjust seat so that the feet are flat on the floor. The forearms
should rest on the desk to keep the muscles in the shoulders
and neck relaxed. The angle at the knee should be at least 90°.
If you experience painful pressure in the thighs, lower the height
of the desk or use a foot support.
Permanent-Contact
The backrest should be set predominantly with Permanent-
Contact engaged. To this end, pull the lever
leaning against the backrest (safety feature to prevent
unintentional activation). The activated Permanent-Contact
feature encourages dynamic seated posture and is beneficial
to the muscles in the upper body. The backrest is free to
move and follows the movements of the upper body.
14
➊
.
➋
upwards while
The counterpressure of the backrest supports the upper body
and relieves the pressure on the intervertebral discs in the
lumbar region. As soon as you press the lever down, the
synchronised tilt locks in position (5-step locking position).
Backrest height
Press the adjustment button in the backrest to release the
➌
lock . Adjusting the backrest height permits individual
positioning of the lumbar support. Set the centre of the lumbar
support (where the upholstery is thickest) at about waist height.
Only in this position is the natural curve of the spine stabilised
and unnatural postures (hollow or rounded back) can be avoided.
Please note: Some models do not have an adjustment button
and the backrest is simply lifted to adjust the height
F
u n c t i o n
GB
E
F
NL
I
➍
.
15
DK