Date & Time Set Procedure; Applying The Cuff - HoMedics BPW-060 Manual De Instrucciones

dATE & TIME SET PRoCEduRE
1. T o adjust the date/time, press the Set button
located on the side of the monitor. The display
will show a blinking number showing the month.
2. Change the month by pressing the
Each press will increase the number by one in
cycling manner. Press the Set button
to confirm the entry, and the screen will show
a blinking number representing the day of the
month.
3. Change the date and time as described in Step
2 above, using the
numbers and the Set button
entries.
repeat process to set date and time

APPLYING THE Cuff

1. R emove all watches, wrist jewelry, etc. prior
to attaching the wrist monitor. Clothing
sleeves should be rolled up and the cuff
should be wrapped around bare skin for
correct measurements.
button.
again
button to change the
to confirm the
Press the button
blinking month
increasing month
confirm the entry
15
2. Apply cuff to left wrist with
palm facing up as shown
in Fig. A.
3. Make sure the edge of the
cuff is about 1/4"~1/2"
(1 cm) from the palm as
shown in Fig. B.
4. In order to insure accurate
measurements, fasten
the hook and loop strap
securely around your
wrist so there is no extra
space between the cuff
and the wrist as shown
in Fig. C. If the cuff is not
wrapped tight enough, the
measurement values will
not be accurate.
5. I f your physician has
diagnosed you with poor
circulation in your left arm,
place the cuff around your
right wrist as shown in
Fig. D.
Fig. A
Fig. B
Fig. C
Fig. D
16