Setting-Up; Projection Methods, Projector - Panasonic PT-LC76U Instrucciones De Funcionamiento

Connector panel
How to open
% &
# $
# MAIN POWER switch
(pages 22 and 24)
$ Power input socket (AC IN)
(page 22)
The accessory power cord is
connected here.
Do not use any power cord other
than the accessory power cord.
% SERIAL connector
(pages 19, 20 and 60)
This connector is used to connect
a personal computer to the
projector in order to externally
control the projector. (RS-232C
compatible)
& RGB1 IN connector
(pages 19 and 20)
This connector is used to input
RGB signals and YP P signals.
B R
' RGB2 IN/RGB1 OUT connector
(pages 19, 20 and 42)
This connector is used to input or
output RGB signals and YP P
B R
signals. Use the RGB2 SELECT
item in the OPTION1 menu to
16-E
NGLISH
' ( * +
) ,
select whether you want input or
output with this connector.
( S-VIDEO IN connector
(pages 19 and 39)
This connector is used to input
signals from a S-VIDEO-compatible
equipment such as a video deck.
The connector is S1 signal
compatible, and it automatically
switches between 16:9 and 4:3
aspect ratios in accordance with the
type of signal being input.
) VIDEO IN jack
(page 19)
This jack is used to input video
signals from a video equipment
such as a video deck.
* AUDIO IN L-R jacks
(pages 19 and 20)
+ Remote control signal receptor
(page 21)
, Menu operation (on connector
panel)
(page 14)
- Remote control unit holder

Setting-up

Projection methods
In way of installing projector, any one of the following four projection methods
-
are used. Select whichever projection method matches the setting-up
method. (The projection method can be set from the OPTION2 menu. Refer
to page 43 for details.)
BFront-desk projection
Menu items
FRONT/REAR
DESK/CEILING
BRear-desk projection
(Using a translucent screen)
Menu items
FRONT/REAR
DESK/CEILING
NOTE:
B You will need to purchase the separate ceiling bracket (ET-PKC80)
when using the ceiling installation method.
B If you set up the projector vertically, it may cause
to damage the projector.
B It is recommended that you set up the projector
in a place that is tilted at less than ±30° . Setting
up the projector in places that are tilted at more
than ±30° may cause malfunctions.
BFront-ceiling projection
Setting Menu items
FRONT FRONT/REAR
DESK DESK/CEILING
BRear-ceiling projection
(Using a translucent screen)
Setting Menu items
REAR FRONT/REAR
DESK DESK/CEILING
Setting
FRONT
CEILING
Setting
REAR
CEILING
E -17
NGLISH