Publicidad
Step 4
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as shown in the upper diagram below. Be
å
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (40MA) to the ENDS (B3 and C3) and UPRIGHTS (D2 and E2). Use twelve GOLD 5/16"
å
FLAT HEAD SCREWS (3S) through holes #1, #3, and #4.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other holes that line up with the holes in the ENDS and UPRIGHTS. Turn a
SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Fasten four ANGLE BRACKETS (27G) to the RIGHT END (B3) and RIGHT UPRIGHT (D2). Use four BLACK 9/16" LARGE
å
HEAD SCREWS (1S).
NOTE: Be sure the edges
å
of the ANGLE BRACKETS
are even with the edges of
the END and UPRIGHT.
GOLD 5/16" FLAT HEAD SCREW
(12 used in this step)
Open end
www.sauder.com/services
40MC
Push the black lever in and pull the SLIDE from the RAIL.
3S
C3
4
3
2
1
Open end
3
E2
4
D2
4
3
2
1
412902
Open end
1
2
4
B3
BLACK 9/16" LARGE HEAD SCREW
(4 used for the ANGLE BRACKETS)
40MA
Open end
1
2
3
27G
(4 used)
27G
1S
Page 11
Publicidad
