Maintenance / Cleaning; Mounting Diagram - GE Evolve Installation Guide

5

MAINTENANCE / CLEANING

WARNING
Risk of electric shock. Make certain power is off before
attempting any maintenance.
• To maintain high efficiency of the lens, occasional
cleaning of the outer lens surface may be needed,
with frequency dependent on local conditions.
• Use a mild soap or detergent, which is essentially
neutral pH (pH approximately 6 to 8), nonabrasive,
and which contains no chlorinated or aromatic
hydrocarbons.

MOUNTING DIAGRAM

(Drill Template to scale)
1.3 in.
(33 mm)
2.9 in.
(74 mm)
These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in
connection with installation, operation or maintenance. Should further information be desired or should particular problems arise which are not
covered sufficiently for the purchaser's purposes, the matter should be referred to GE Lighting.
GE Lighting • 1-888-MY-GE-LED
GE Lighting is a subsidiary of the General Electric Company. Evolve and the GE brand and logo are trademarks of the General Electric Company.
© 2015 GE Lighting. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
• Wash thoroughly, using a soft cloth.
• Rinse with clean, cold water and wipe dry.
6
STORAGE
• Until installation, all units should be placed in a
covered dry storage area. The storage area should
not exceed -40°C (-40°F) to 50°C (122°F).
- This can be preferably in a roofed area or with a
tarp that is secured in such a way to keep water
off of the corrugated boxes (cardboard boxes).
4.4 in. (112 mm)
• www.gelighting.com
(1 - 888 - 69 - 43 - 533)
3.5 in. (89 mm)
Octagonal
J-box
4 in. (102 mm)
Octagonal
J-box
35-201578-226 (Rev 12/14/15)
English