Section
06
Built-in CD Player
Playing a CD
1 Track number indicator
Shows the track currently playing.
2 Play time indicator
Shows the elapsed playing time of the cur-
rent track.
1
Insert a CD into the CD loading slot.
Playback will automatically start.
# You can eject a CD by pressing EJECT.
2
After a CD has been inserted, press
SOURCE to select the built-in CD player.
3
Use VOLUME to adjust the sound level.
4
To perform fast forward or reverse,
press and hold c or d.
5
To skip back or forward to another
track, press c or d.
Pressing d skips to the start of the next track.
Pressing c once skips to the start of the cur-
rent track. Pressing again will skip to the pre-
vious track.
Notes
! The built-in CD player plays one, standard, 12-
cm or 8-cm (single) CD at a time. Do not use
an adapter when playing 8-cm CDs.
12
En
1
2
CD loading slot
! Do not insert anything other than a CD into
the CD loading slot.
! If you cannot insert a disc completely or if
after you insert a disc the disc does not play,
check that the label side of the disc is up.
Press EJECT to eject the disc, and check the
disc for damage before inserting the disc
again.
! If the built-in CD player does not operate prop-
erly, an error message such as ERROR-11
may be displayed. Refer to Understanding
built-in CD player error messages on page
17.
Repeating play
Repeat play lets you hear the same track over
again.
1
Press 5 to turn repeat play on.
RPT appears in the display. The track currently
playing will play and then repeat.
2
Press 5 to turn repeat play off.
The track currently playing will continue to
play and then play the next track.
Note
If you perform track search or fast forward/re-
verse, repeat play is automatically cancelled.
Pausing CD playback
Pause lets you temporarily stop playback of
the CD.
1
Press 6 to turn pause on.
PAUSE appears in the display. Play of the cur-
rent track pauses.
2
Press 6 to turn pause off.
Play will resume at the same point that you
turned pause on.