Spark Plug - Honda CRF230F Manual Del Propietário

54
10. Start the engine and let it idle for 3 – 5 minutes.
11. 2 – 3 minutes after stopping the engine, check that
the oil level is at the upper level mark on the oil
filler cap/dipstick with the motorcycle upright
on firm, level ground. Make sure there are no
oil leaks.
(4) (2)
(3)
NOTICE
Running the engine with insufficient oil can cause
serious engine damage.
(1) Oil drain plug
(2) O-ring
(3) Spring
(4) Oil strainer
screen
(1)

Spark Plug

(Refer to the Safety Precautions on page 42.)
Recommended plugs:
Standard: DPR8EA – 9 (NGK) or
X24EPR – U9 (DENSO)
For cold climate: (Below 5°C, 41°F)
DPR7EA – 9 (NGK) or
X22EPR – U9 (DENSO)
NOTICE
Never use a spark plug with an improper heat range.
Severe engine damage could result.
1. Disconnect the spark plug cap (1) from the spark
plug.
2. Clean any dirt from around the spark plug base.
3. Remove the spark plug with the spark plug wrench
(2) and handle (3) provided in the tool bag.
(3)
(1)
CRF230F • CRF230F (U Type)
(1) Spark plug cap
(2) Spark plug
wrench
(3) Handle
(2)