Spark Plug - Honda CRF150F 2017 Manual Del Propietário

50
4. Check that the sealing washer on the drain bolt
is in good condition and install the bolt. Replace
the sealing washer every other time the oil is
changed, or each time if necessary.
Oil drain bolt torque:
30 N . m (3.1 kgf . m, 22 lbf.ft)
5. Fill the crankcase with the recommended grade
oil; approximately:
1.0 liter (1.1 US qt, 0.9 Imp qt)
6. Install the oil fill cap/dipstick.
7. Start the engine and let it idle for 3 – 5 minutes.
8. 2 – 3 minutes after stopping the engine, check
that the oil level is at the upper level mark on the
oil fill cap/dipstick with the motorcycle upright on
firm, level ground. Make sure there are no oil
leaks.
9. Install the engine guard, bolt A, collar and bolts
B.
NOTICE
Running the engine with insufficient oil can cause
serious engine damage.

Spark Plug

(Refer to the Safety Precautions on page 39.)
Recommended plugs:
Standard: CPR8EA – 9 (NGK)
For extended high speed riding: CPR9EA – 9 (NGK)
NOTICE
Never use a spark plug with an improper heat range.
Severe engine damage could result.
1. Disconnect the spark plug cap (1) from the spark
plug.
2. Clean any dirt from around the spark plug base.
3. Remove the spark plug with the spark plug wrench
(2) and handle (3) provided in the tool bag.
(1)
(1) Spark plug cap
(3)
(2) Spark plug
wrench
(3) Handle
(2)
CRF150F