User Maintenance - Andis US-1 Instrucciones De Uso Y Cuidados

11. WARNING: During use, do not place or leave
appliance where it may be (1) damaged by an
animal or (2) exposed to the weather.
12. Oil blades frequently. Blades may become
hot during use.
13. Keep the appliance dry.
14. Cleaning and user maintenance shall not be
made by children without supervision.
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
Before starting the clipper remove the blade guard. Plug the cord into an
electrical outlet, operate at 230-240 volt, 50 cycle AC electrical current (Argentina
220V, 50Hz) or as noted on the unit. To start the clipper move the switch button
to the ON position. To stop, move the switch button back to the original position.
After using your Andis clipper, rewrap the cord and store in a safe place.
USING THE ATTACHMENT COMBS
(Some models do not have combs and sizes will vary by kit)
You can set the blades for a longer cut by using any of the attachment combs
made for your Andis clipper. The combs mount easily; simply slip the cutter
blade teeth into comb and snap the comb down. To remove, simply snap off
(Figures A & B). These attachment combs guide hair into the blades and give
you precise control of hair lengths. The length of trim is indicated on the
attachment comb. Use the chart to find the approximate lengths of cut. Different
blade angles in relation to the skin, thickness and texture of the hair will vary the
cutting length.
CLIPPER BLADE ADJUSTMENT
Your Andis adjustable clipper blade set is easy to adjust. From coarse to fine
cuts, all that is needed is a flick of the adjustment lever with your thumb. In the
upright position, the blades are set for the finest, or shortest cuts (Figure C).

USER MAINTENANCE

The internal mechanism of your clipper has been permanently lubricated at the
factory. Other than the recommended maintenance described in this manual, no
other maintenance should be performed, except by Andis Company or an Andis
authorized service station.
4