Kalorik USK TO 37895 Manual De Instrucciones página 5

Fax +1 305 430 9280
BEFORE USING THE TOASTER FOR THE FIRST TIME
Note: the bread carriage handle will not stay down if the appliance is
not plugged in!
In order to eliminate any manufacturing residues, operate the toaster
a couple of times without bread with the browning control selector
on a medium browning level. Some smoke might escape, which is
perfectly normal.
OPERATION
Before using your appliance for the first time, check if it is clean
•
(see "Maintenance and cleaning") as it comes into direct
contact with bread. Check if any object has fallen into the slots.
Place the bread slices in the slots (for the French bread, cut a loaf
•
shorter than the slots, then cut it in two pieces along its length.).
Your appliance is provided to receive French bread, but also
pieces of toast or other bread slices if their thickness and their
length are shorter than the one of the slots. The maximum
thickness allowed for bread is 30mm / 1 ¼".
Press down the bread carriage handle until it stops (at the same
•
time, the grid inside the slots will tighten around the bread in
order to keep it away from the heating wires). Then release the
pressure and the handle will stay in the lower position, which
means that the heating process has begun. If the handle comes
up immediately, check if the appliance is plugged in, as the
bread carriage cannot be locked if the toaster is not plugged-in.
You can adjust the browning intensity to obtain a more/less
•
toasted bread, by positioning the browning control selector to
one of the degrees marked from 1 to 7. Therefore you only have
to turn clockwise to increase the browning intensity, and
anticlockwise to decrease it. The higher the number is, the more
toasted the bread will be.
During operation, if you think that the bread is toasted enough or
•
for any another reason, you can stop the heating process, simply
by pressing the Cancel button.
Copies of the I/B. Please reproduce them without any
changes except under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
5
Assembly page 5/24
special instruction from Team
Print only
USK TO 37895/37896 - 120501