RECARO CV Seat 1 Manual De Montaje página 41

K
5. Using the supplied pneumatic quick-action coupling in the hose/cable harness adapter: Connect
up the vehicle's Ø 6 mm pneumatic hose to the hose/cable harness by pushing it as far as it will go into
the seat's quick-action coupling (1).
Alternatively:
Using a cutting ring (not included in the package): Remove the cutting ring from the standard seat's
pneumatic connection and then withdraw the swivel nut. Shorten the hose/cable harness adapter's
pneumatic hose by 10 cm and then fit the swivel nut and a new cutting ring to the swivel coupling
L
2
6. Connect the electrical plug connections (2) and then fold the floor panel (1) back into its original
position.
Important note:
The electrical connections for the seat's power supply (plus / minus) must be established by
specialist. See the circuit diagram in Chapter 5.
7. Activate the express down mechanism.
8. Start the vehicle in order to build up the air pressure needed for the remaining part of the installation.
RECARO Automotive Seating
1
6mm
1 Pneumatic connection
K0231
1
1 Floor panel
2 Plug connections
K0233
Page 17