RECARO CV Seat 1 Manual De Montaje página 43

12. Tightly screw the two screws (2) at the front into the adapter using the stipulated torque (use the T40
Torx adapter).
Torque: M8 screws: 25 Nm ± 2 Nm
13. Now move the seat as far forward as possible.
14. Screw the two centre screws (3) from the installation kit into the adapter (finger-tight only).
15. Tightly screw the four screws (3, 4) at the rear into the adapter using the stipulated torque.
Torque: M8 screws: 25 Nm ± 2 Nm
Danger:
If the torque is not set correctly, the screws will work loose whilst you are driving.
In this case, the safety concept can no longer be ensured and the vehicle may no longer be used.
The screws must be tightened using the stipulated torque.
RECARO Automotive Seating Page 19