6. Lifting weights, until steady 4 to 5 seconds.
7. Press the A key on remote control to show "--------", 2 seconds after the
display of the hanging weight values, calibration is finished, put weight
down, turn it off.
DIvISION SETTINg
1. Post holding down the D key on remote control and so display "CAL SP".
2. Press the D key on remote control to display "SET".
3. Press the A key on remote control to display "dx".
4. With D key on remote control to change the division value.
5. When finished, press the A key on remote control to view the largest
weighing.
6. Press the A key on remote control to show "fLT 00".
7. Press the A key on remote control to show "rng 1" (1 indicates zero
tracking parameters).
8. Press the A key on remote control to show "AUPf0".
9. Press the A key on remote control to back to normal weighing mode.
9