Safety Information; Functions; General Information - Trix TRAXX2 F140 AC 2 Manual De Instrucciones

Safety Informations
• This locomotive is to be used only with an operating system
designed for it.
• Use only power packs rated for your local household power.
• This locomotive must never be supplied with power from
more than one power pack.
• Pay close attention to the safety warnings in the instructions
for your operating system.
• Do not expose the model to direct sunlight, extreme changes
in temperature, or high humidity.
• The feeder track must be equipped to prevent interference
with radio and television reception, when the locomotive is
to be run in conventional operation. The 611 655 interference
suppression set is to be used for this purpose. The interfe-
rence suppression set is not suitable for digital operation.

Functions

• This model is designed for operation with H0 2-rail DC
systems (track according to NEM standards) with con-
ventional DC power packs.
• This locomotive comes equipped with a Trix connector for
digital operation and can have the Trix locomotive decoder
66839/66849 installed in it.
• Trix motor vehicles must not be operated on digital systems
without an built-in engine decoder (Motor can be damaged!).

General Information

• The operating instructions are a component part of the product
and must therefore be kept in a safe place as well as included
with the product, if the latter is given to someone else.
• Please see your authorized Märklin dealer for repairs or
spare parts.
• http://www.maerklin.com/en/imprint.html
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed in
Trix products or where Trix products have been converted in such a way
that the non-Trix parts or the conversion were causal to the defects and /
or damage arising. The burden of presenting evidence and the burden of
proof thereof, that the installation of non-Trix parts or the conversion in or
of Trix products was not causal to the defects and / or damage arising, is
borne by the person and/or company responsible for the installation and /
or conversion, or by the customer.
7