Safety Information - Trix 22608 Manual Del Usuario

Function
• Built-in electronic circuit for operation with a conventio-
nal DC power pack (max. ±12 volts), Trix Systems, Trix
Selectrix or NMRA DCC digital systems.
• Automatic system recognition between digital and
analog operation.
• No automatic system recognition between Selectrix (SX)
and DCC.
• The full range of functions is only available under Trix
Systems and under DCC.
• Headlights for the locomotive change over with the
direction of travel. They can be turned on and off in
digital operation.
• Depending on the length of the train, a stop or braking
block must be relatively long, so that the train will
remain stopped as desired.
Notes on operation with direct current
• A filtered direct voltage is required for operation.Ope-
rating systems with pulse duration control are therefore
unsuitable.
Notes on digital operation:
• The first time the locomotive is used in a digital system
(Selectrix or DCC), the decoder must be set for this di-
gital system. To do this, the decoder must be program-
med once in this digital system (Example: changing an
address).
All manuals and user guides at all-guides.com
• The operating instructions for your central unit will give
• The values set at the factory were selected to guarantee
• This locomotive comes from the factory programmed
• Correct programming with the 66920 Mobile Station is
• Information about DCC Operation:

Safety Information

• This locomotive is only to be used with the operating
• This locomotive must not be supplied with power simul-
• Please make note of the safety information in the
• The feeder track must be equipped to prevent inter-
you exact procedures for setting the different param-
eters.
the best possible running characteristics.
for the digital address „01" (Selectrix) / „03" (DCC)
Number of speed levels that have been set: 28 (DCC)
and 31 (Selectrix).
possible starting with version number 034.
The setting done at the factory does not permit opera-
tion with opposite polarity DC power in the braking
block. If you want this characteristic, you must do with-
out conventional DC power operation (CV29 / Bit 2 = 0).
system it is designed for.
taneously by more than one power source.
instructions for your operating system.
ference with radio and television reception, when the
locomotive is to be run in conventional operation. The
611 655 interference suppression set is to be used for this
7