Health O Meter Professional 2600KL Instrucciones De Uso página 8

ASSEMBLY INSTRUCTIONS (CONT)
6. Obtain the display head and align the tab
slots on the back of the display head with
the tabs on the silver display support.
Slide the slots on the display head onto
the tabs in the bracket.
7. Align the four holes on the back of the
display head with the four mounting
holes on the silver display support. Using
the four included M4 0.7 x 10mm screws
(Part B), fasten the display head onto the
display support using a Phillips head
screwdriver to tighten the screws.
8. Obtain the plastic bracket cover. Clip the
load cell cable into the divot in the middle
of the cover and align the cover over the
silver display support. Obtain the two
remaining M4 0.7 x 10mm screws (Part
A). Using a Phillips screwdriver, attach
the bracket cover over the silver display
bracket.
9. Plug the load cell cable into the load cell
port on the rear of the display head.
Note: Do not attach the AC adapter
power cord into the back of the display
assembly at this point.
9. Attach the two display support covers
(Part C) on the front and back of the
scale as shown. Scale assembly is
complete. See Powering the Scale on
page 10 for battery/AC adapter
instructions. If powering the scale via AC
adapter, see the next step for attaching
the adapter holder.
10. Optional Step – For powering the
scale via AC power adapter. Attach the
adapter holder to the handrail using the
two included sheet metal screws (Part
B). Use a Phillips head screwdriver to
tighten the screws.
P/N UM2600KL_ 2600KG_2610KL_2610KG_E_REV20190827_web
Slots on back of display head
Slide slots onto tabs in bracket
8