Making A Bag Using The Bag Roll - Caso GERMANY VC100 Instrucciones De Funcionamiento Originales

16.5 Making a bag using the bag roll

caso Vakuumierer VC100
the bag. Foreign objects or creased bags may cause
difficulty to seal tightly.
► Do not leave too much air inside the bag. Press the bag to
allow extra air to escape from the bag before vacuuming it.
Too much air inside the bag increases the vacuum pump
loading and may cause that the motor works insufficient to
draw away all the air out of the bag.
► If the foods you're sealing have sharp edges, such as bones,
spaghetti or shellfish, pack the edges with kitchen paper to
avoid tearing the bag
► Suggest to vacuum seal one bag within 1 minute to let the
appliance cool down enough.
► In order to vacuum seal liquid-based foods, such as soups,
casseroles or stew, freeze them first in a baking pan or
tempered dish, vacuum seal them, label and stack them in
your freezer as soon as they are in frozen solid.
► Blanch the vegetables by cooking briefly in boiling water or
microwave oven, cool them down , then vacuum seal them
in convenient portions.
► To vacuum seal the foods not frozen, two extra inches are
required for bag length to allow for expansion while freezing.
Place the meat or fish on a paper towel and vacuum seal
with the paper towel in the bag, this way will help to absorb
moisture from the foods.
► Before storing the foods such as tortillas, crepes or
hamburger, use wax or parchment paper between them to
stack the pieces, this will be easier to remove some of the
food, reseal the rest and immediately replace in the freezer.
► These vacuum bags are not recommended for microwave or
boil-in-bag cooking, please use the general cooking methods
to reheat the vacuum-sealed foods.
1. Unroll the foil to the desired length and cut the bag to the
appropriate length with precise and clear cut.
2. Open the lid and put one end of the bag on top of the black
rubber strip, then close the cover (see Step 1).
3. Press the cover down heavily on both sides by using two hands
until two click sounds heard (see Step 2).
4. Press the "Schweißen"-Button (B) and the corresponding LED
control light starts flashing.
Operation and Handling
52