Disposal Of The Old Device - Caso GERMANY VC100 Instrucciones De Funcionamiento Originales

The bag does not hold
the vacuum after it has
been welded shut

19 Disposal of the Old Device

caso Vakuumierer VC100
The bag is defective
There are leaks along the
welding seam as a result of
creases, crumbs, grease or
liquids.
► If you are unable to solve the problem with the steps shown
above, please contact Customer Service.
Old electric and electronic devices frequently still contain
valuable materials. However, they also contain damaging
substances, which were necessary for their functionality and
safety.
If these were put in the non-recyclable waste or were handled
incorrectly, they could be detrimental to human health and the
environment. Therefore, do not put your old device into the non-
recyclable waste under any circumstances.
Utilise the collection point, established in your town, to return
►
and recycle old electric and electronic devices. If necessary,
contact your town hall, local refuse collection service or your
dealer for information.
Ensure that your old device is stored safely away from
►
children until it is taken away.
► Select another bag; wrap
paper serviettes around any
sharp edges on the content
► Open the bag again and
clean the upper internal part
of the bag and remove any
foreign matter that might be
on the welding bar before you
weld the bag shut again.
Please note
Please note
Troubleshooting
57