Quick Setup - Panasonic BL-WV10 Guía De Configuración Inicial

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Getting Started
3.6

Quick Setup

Issue
The camera cannot be set
as a local camera.
34
Causes and Solutions
Are you attempting to perform Quick Setup on a
camera already configured using a computer?
To use Quick Setup to register cameras as
local cameras, set the [User Name] and
[Password] on the [Easy Network Setup]
screen to the same values already stored in
the cameras.
Is the firmware version of the camera out of date?
Before connecting your cameras to the
BL-WV10, make sure that each camera's
firmware version meets the requirements
noted on page 6. If necessary, refer to the
operating instructions included with the
camera and update the firmware.
Cameras that have been registered as remote
cameras cannot be re-registered as local cameras
even after re-initializing.
In the [Camera Setup] screen in normal
mode, erase the camera, then re-initialize it,
and then perform Quick Setup.
When performing Quick Setup on cameras when 2
BL-WV10s are in use, those for one of the BL-WV10s
will be registered as local cameras, but those for the
other BL-WV10 will be registered as remote
cameras.
First, make sure that the administrator name
and password for the cameras is identical on
both BL-WV10s. Next, connect the cameras
to each BL-WV10 prior to connecting the
BL-WV10s to each other.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido