Panasonic BL-WV10 Guía De Configuración Inicial página 35

Issue
I cannot use Quick Setup. Quick Setup will work for a maximum of 8 cameras.
No router is displayed,
even though one is
connected.
Display indicates no
wireless router.
Display indicates that no
wireless router was found.
Camera Quick Setup fails. Are you following the procedures shown in this
[Setting wireless
parameters...] appears.
Causes and Solutions
Is the Ethernet cable connected properly?
• If the Ethernet cable is connected properly,
the LAN indicator will be lit green.
Quick Setup can only be performed within 20 minutes
of turning on a camera that still has its default settings
(as at time of purchase).
• Turn the camera on again.
When performing Quick Setup on a wireless camera
with a wired/wireless switch, such as the BL-C30, is
the camera switch set to wired?
When performing Quick Setup on a computer for
cameras already initialized, is the IP address the
same as that for the BL-WV10?
Was the router turned on before the BL-WV10?
• Turn the router on and wait 2 minutes or more
before turning the BL-WV10 on.
Is the DHCP server option in the router settings
turned off?
• Quick Setup cannot be performed. Launch
the BL-WV10 in normal mode, and manually
perform network settings from the Setup
menu.
The BL-WV10 does not support wireless routers.
The BL-WV10 does not support wireless routers.
document?
• If registration fails, re-initialize the camera,
turn the BL-WV10 off and then on again, and
re-perform Quick Setup.
In addition to the router, is there another Panasonic
device serving as an access point?
• Remove that access point from the network,
and turn the BL-WV10 off and then on again.
This message is displayed when another BL-WV10 is
connected. It indicates that the connected devices
will have the same wireless settings configured for
them.
Getting Started
35