LGB Ge 4/4 III Serie Manual De Instrucciones página 9

Ocultar thumbs Ver también para Ge 4/4 III Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
Pantographs
This model is equipped with electronically controlled pantographs. The rear panto-
graph is raised and the front pantograph is lowered automatically depending on the
direction of travel. The pantographs can be fixed in the lowered position by clipping
them into the restraints.
When operating with the LGB Multiple Train System the locomotive can be set with
the F7 button so that both pantographs are raised (see Multiple Train System). This
setting will remain preserved after the layout is shut off.
Programming the Decoder
Numerous functions on the decoder can be programmed individually. To do this,
function values are programmed in registers (Configuration Variables - CVs). You also
can program the function values with the 55015 Universal Remote Controller.
• For normal operation, it is not necessary to change the function values.
• If programming results in unsatisfactory operation, you can reprogram the factory
pre-set values of most important CVs: Program register CV 55 to function value 55.
To reprogram the factory pre-set function values with the 55015, select program-
ming mode "P" (displays shows "P --"). Then input 6, 5, and 5 and press the right
arrow button. The display shows "P --" again: Input 5, 5, and 5 and press the right
arrow button again.
SERVICE
Lubrication
Oil each of the axle bearings now and then with a drop of Märklin oil (7149).
Changing Light Bulbs
Headlights: Carefully lift the glass from the lantern. Pull the light bulb out of the socket
with a pair of tweezers. Insert new light bulb. Put the model back together.
Interior Lighting: Pull the light bulb out of the socket with a pair of tweezers. Insert
new light bulb.
Changing Traction Tires
• Remove the old traction tire with a small flat blade screwdriver:
• Lift the old traction tire out of the groove in the driving wheel.
• Carefully push the new traction tire over the wheel and insert it into the groove of
the wheel.
• Check to make sure that the traction tire is properly seated.
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

27425

Tabla de contenido