Troubleshooting - Beko BEMPE 090 Manual Del Usuario

7

Troubleshooting

Check the following before requesting on service centre of BEKO if the malfunction occurs.
Phenomenon
Air conditioner dose not operate
at all
Remote controller is not
available
Cooling (Heating) efficiency is
not good
Indoor unit does not operate
immediately when the air
conditioner is restarted
There is unusual smell blowing
from the outlet after operation
is started.
Sound of water flow can be
heard during cooling operation
Mist is emitted during cooling
operation.
Mist is emitted during heating
operation.
A low hissing sound is caused by
the refrigerant flowing.
20 / 172 EN
• Has the power been shut down?
• Is the wiring loose?
• Is the voltage higher than 1.1 times of max rated voltage or
lower than 0.9 times of min rated voltage?
• Is the fuse burnt?
• Does it reach the set time for start up?
• Is the remote controller out of effective distance to the indoor
unit?
• Is the battery exhausted?
• Are there any obstructions between the controller and the
signal receptor?
• Is the setting temperature suitable?
• Is the air inlet or outlet obstructed?
• Are air filter dirty?
• Is indoor fan speed set at low speed?
• Is there any heat source in your room?
Once the air conditioner is stopped, it will not operate in
approximately 3 minutes to protect itself.
This is caused by the odour in the room permeated from building
material, furniture, or smoke.
This is caused by the refrigerant flowing inside the unit.
Because the air of the room is cooled down rapidly by the cold
wind and it looks like the fog.
This generate due to moisture in defrosting process.
• Low noise can be heard during operation
• A low squeak sound is caused by the deformation of plastic
due to temperature.
Free match split type air conditioner / User Manual
Troubleshooting