Check The Water Exhausting - Beko BEMPE 090 Manual Del Usuario

11 Installation of the indoor unit
• Before installation, confirm connection pipes' direction.Remove the board 1 and board 2 on the
correct connecting side. Press connection pipes to the board gap, then install board 2 to the
original location. If connection pipes are on the other side, install them as above.
Note: The installed air-conditioner won't be tightly appressed to the wall if that is
C
not arranged shown in the picture. The outflow tube must be in the bottom and the
highest point of it can not exceed the position of water basin.

11.3 Check the water exhausting

1. Take off the frame the unit cover. Take off the front frame for maintenance according to the
following steps:
• Turn perpendicular airflow direction handle from " I " to horizontal direction.
• As shown in the picture on the below, take off two covers from the front frame and then unfasten
two fixture screws.
• Pull the front frame towards yourself and take it off.
32 / 172 EN
Board 1
Board 2
Pull off
Plastic
strap
Wall Air-conditioner
Connection
pipe
Installation
Cable
board
Wall
Installation board
Free match split type air conditioner / User Manual
Board 3
Board 4
Drain pipe
Connection
pipe
Cable
Cable
Outflow tube
Base
Connection pipe
Cable
Outflow tube