Troubleshooting Guide - BH FITNESS YL30 Manual Del Usuario

NOTE: This is not a medical appliance
and therefore the heart rate shown is
merely for guideline purposes.
SCAN
Scans through the following functions
every 8 seconds:
Strokes per minute; Calories; Pulse;
Strokes and Time.
Press the MODE key until the arrow
moves onto SCAN, press the MODE
key and the Scan function will be
displayed with the arrow flashing.
To cancel the Scan function and
display just one specific value, press
the MODE key and the arrow will stop
flashing on the chosen function.
DISTANCE.
Indicates the distance covered in km
or nautical miles, simulating the stroke
of a light boat.
The distance simulated between 8 and
12 m., depends on the intensity and
length of the stroke.

TROUBLESHOOTING GUIDE

Problem: The display comes on but
only the Time function works.
Solution:
a. Make sure that the connection
cable is connected.
Problem: The display does not come
on or the displayed segments are very
Total strokes;
weak
Solution:
a. Check that the batteries are fitted
correctly.
b. Check the battery charge
c. If they are run down change them
immediately
Problem: Display segments of a
function read-out are not visible or
error messages
function appear.
Solution:
a. Remove
seconds and then refit them correctly.
b. Check the battery charge If they
are run down change the batteries
c. If the above steps do not help then
replace the electronic monitor.
Avoid leaving the electronic monitor in
direct sunlight as this might damage
the liquid crystal display. Similarly, do
not expose it to water or knocks.
THE MANUFACTURER RESERVES
THE RIGHT
SPECIFICATIONS
PRODUCTS
NOTICE.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any
customer services (see last page in
manual)
6
for a particular
the batteries
TO MODIFY
OF
WITHOUT
queries by
for 15
THE
ITS
PRIOR
phoning