Troubleshooting Guide - BH FITNESS G2334N Manual Del Usuario

The test will not work if the sensor is
not positioned correctly or if the letter
"P" is shown on the screen.
HAND-GRIP
STRUCTIONS/USE.-
On this model the pulse rate is
measured by placing both hands on the
sensors (R), located on the handlebar,
as shown in Fig.3.
When both hands are placed on the
sensors the heart symbol on the right-
hand side of the screen, marked
PULSE, will begin to flash and after a
few seconds a heart rate reading will
be displayed.
If both hands are not placed correctly
as shown in Fig.3 then the pulse
function will not work.
If the heart symbol does not flash then
make sure that both hands are placed
on the sensors and that the connectors
are connected at the back of the
electronic unit.

TROUBLESHOOTING GUIDE

Problem: The display comes on but
only the Time function works.
Solution:
a.- Make sure that the connection cable
is connected.
Problem: The display does not come
on or the displayed segments are very
weak.
(PULSE) IN-
Solution:
a.- Check that the batteries are fitted
correctly.
b.- Check the battery charge.
c.- If they are run down change them
immediately.
Problem: Display segments of a
function read-out are not visible or error
messages for a particular function
appear.
Solution:
a.- Remove the batteries for 15
seconds and then refit them correctly.
b.- Check the battery charge If they are
run down change the batteries.
c.- If the above steps do not help then
replace the electronic monitor.
Avoid leaving the electronic monitor in
direct sunlight as this might damage
the liquid crystal display. Similarly, do
not expose it to water or knocks.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
8