Static Electricity - UFESA AC6201 Manual Del Usuario

SUGGESTION
Information on the product
and suggestions for its use
●
The vacuum cleaner is for household use only.
●
Operate the appliance only in indoor spaces and
vacuum only dry surfaces. Before vacuuming dry
the carpets that were wet cleaned.
●
Vacuum cleaner is a universal device with
a switchable sucking brush nozzle, which is used
for vacuuming hard floors and carpets.
Technical parameters
The type of the vacuum cleaner and the technical
parameters are indicated on the rating label. Mains
protection 16 A.
Does not cause interferences with audio/video devices.
Does not require grounding
Vacuum cleaners meet the requirements of the applicable
norms.
The appliance is in conformity with the requirements of
the directives:
– Electrical equipment designed for use within specific
voltage limits (LVD) – 2006/95/EC.
– Electromagnetic compatibility (EMC) – 2004/108/EC.
The device meets the requirements of Commission
Regulation (EU) No. 666/2013 on implementing
the Directive of the European Parliament and of the
Council 2009/125/EC with regard to eco-design
requirements for vacuum cleaners.
The device complies with the requirements of the
Commission Delegated Regulation (EU) No. 665/2013
supplementing Directive of the European Parliament
and of the Council 2010/30/EU with regard to energy
labelling of vacuum cleaners.
Noise level: 77 dB(A).
The appliance was marked by a CE sign on the rating
label.

Static electricity

In the process of vacuuming of some surfaces in areas
of low air humidity the device may become electrically
charged. It is a natural phenomenon – it does not
damage the device, and it is not considered to be a fault.
In order to minimize the phenomenon, we recommend
you to:
● discharge the device by touching metal items in the
room with the pipe,
.
● increase air humidity in the room,
● use widely available antistatic agents.
Appliance elements
1 Accessory compartment cover
2
Combination brush fastening
3
Plug and cord
4
Cord rewind button
5
Outlet filter cover
6
Handle
7 ON/OFF button
8
Dust bag full indicator
9
Power decrease button
10
Suction power level indicator
11
Power increase button
12
Upper cover fastening
13 Suction hose
14
Telescopic suction tube
15
Outlet filter EPA E11 (installed in the vacuum cleaner)
16
Inlet filter (installed in the vacuum cleaner)
17
Inlet filter casing (installed in the vacuum cleaner)
18
SAFBAG dust bag module (with the installed
SAFBAG dust bag)
19
Parquet brush "BNB"
20
Switch-over nozzle brush
21
Small nozzle
22 Crevice nozzle
23
Small brush
Preparing the vacuum cleaner for
operation
1
Insert the curved hose end in the opening of the
vacuum cleaner and gently press. A characteristic click
indicates that the hose has been properly installed.
2
Connect the other end of the hose (handle) with
the telescopic suction tube. In order to do so press
the locking device "A" and slide the tube into the hose
handle so that the locking device "A" is blocked in
opening "B".
3
Adjust the length of the telescopic suction tube by
sliding the slider according to the arrow and pull out/
pull the tube together.
4
Assemble the appropriate nozzle or brush to the
other end of the suction tube.
A
B