Description Of The Appliance; Before Startup; Attaching The Accessories - Kärcher K 4 Manual De Instrucciones

Description of the Appliance

Illustrations on fold-out page!
1 Coupling element for water
connection
2 Quick coupling for high pressure hose
3 Storage for trigger gun
4 Water connection with integrated sieve
5 Appliance switch "0/OFF"/ „I/ON"
6 Dosage regulator for detergent
7 Storage for trigger gun
8 Transport handle
9 Storage of Plug 'n' Clean detergent
bottle with detergent connection
10 Plug 'n' Clean detergent bottle with
locking lid
11 Storage for high pressure hose
12 Storage hook for mains connection
cable
13 Storage for spray lance
14 Mains cable with mains plug
15 Bearing wheel
16 Trigger gun
17 Lock trigger gun
18 Key to detach the high pressure hose
from the trigger gun
19 High pressure hose
20 Spray lance with pressure regulation
(Vario Power)
Carrying out the most common cleaning
tasks. The work pressure can be stage-
lessly regulated between "Min" and
"Max". You can add detergent when
"Mix" is selected.
In order to adjust the working pressure,
release the lever of the hand spray gun
and turn the spray lance to the desired
position.
21 Spray lance with Dirtblaster
For strong contaminations
———————————————–
Not included in the delivery
22 Water supply hose
Use a fabric reinforced water hose with
a commercially available coupling. Min-
imum diameter 13 mm (1/2 inch); mini-
mum length 7.5 m.
8 English

Before Startup

Attaching the Accessories

Illustrations on fold-out page!
Mount loose parts delivered with
appliance prior to start-up.
Install wheels
Illustration
 Push the wheels into the intake.
 Secure the wheels using the included
plug. Align the plug properly!
Install the storage for trigger gun
Illustration
 Place the bottom holder into the recess-
es and push forward until it audibly
locks in.
 Insert the top holder and push down all
the way.
Install the transport handle
You will need the 2 included screws as well
as a Phillips screwdriver PH 2.
Illustration
 Slide the transport handle into the guide
and secure it with 2 screws.
Install the dosage regulator for
detergent
You will need the 2 included screws as well
as a Phillips screwdriver PH 2.
Illustration
 Insert both detergent hoses onto the
hose fittings.
 Install the dosage regulator and con-
nect using 2 screws.
Note: During installation you must
make sure that the tongues of the dos-
age regulator match up with the intend-
ed recesses in the casing.
Connect the high pressure hose to the
trigger gun
Illustration
 Push the high pressure hose into the
trigger gun until it locks audibly.
Note: Make sure the connection nipple
is aligned correctly.
Check the secure connection by pulling
on the high pressure hose.