Publicidad
Idiomas disponibles
Idiomas disponibles
LOAD CRAFT AND ADJUST POSITION
• Place craft in Saddles.
• Loosen hardware to adjust
position of saddles.
CENTER CRAFT
ON SADDLES
• Position your boat to
• Saddles will deform for
Secure front and rear of boat to vehicle at bow and
stern before driving away.
STRAPS AND BOW/STERN TIE-DOWNS
can be purchased at your Yakima Dealer, online,
or at (888)925-4621, Monday through Friday, 7:00 AM to 5:00 PM, PST.
1032387D-3/12
FIT BOAT TO
SADDLES
allow maximum contact
with saddle surfaces.
a close fit with hull after
straps are tightened.
Tighten all hardware
after adjusting
position of saddles.
(Tie-downs not included)
SET OF 2
HEAVY DUTY
STRAPS
#05006
(Saddles can slide
on crossbars.)
USE STRAPS TO SECURE CRAFT
(Straps not included)
Do not loop
straps through
saddles! Attach to
crossbars only.
BOW/STERN
(Saddles can be rotated on the
attachements to fit the hull.)
• Loop strap around front
crossbar as shown.
• Strap must be inboard of
tower.
• Repeat for rear crossbar.
• TIGHTEN STRAPS.
Failure to secure front and
rear of long loads to ends
of vehicle can result in
property damage, personal
injury, or death.
SET OF 2
TIE-DOWN
#04031
Publicidad
