Publicidad
Step 12
Step
1
D14
O
Groove
Insert the LARGE DRAWER SIDES (D14 and D15)
å
at an angle into the slot at each end of the LARGE
DRAWER FRONT (O).
3
Fasten the LARGE DRAWER BACK (D78) to the LARGE DRAWER
å
SIDES (D14 and D15). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D716) inserts into the groove of the LARGE DRAWER BACK (D78).
å
Page 16
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D15
D78
D14
D716
VIEW THE T-LOCK BOX VIDEO
2
D14
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D716) into the grooves in
å
the LARGE DRAWER SIDES (D14 and D15) and LARGE
DRAWER FRONT (O).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D15
422811
With the palm of
your hand, tap the
DRAWER BOTTOM
U n
down into the groove.
fi n
s u
i s h
r f a
e d
c e
D716
D15
O
30S
(4 used in this step)
www.sauder.com/services
Publicidad
