Publicidad
Step 2
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as
å
shown in the upper diagram below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (35MA) to the LEFT END (B) and UPRIGHT (C2). Use
å
four GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the
å
enlarged diagram. Then, slide the inner cartridge of the EXTENSION RAIL out to fi nd
the other hole that lines up with the hole in the END and UPRIGHT. Turn a SCREW
into this hole.
NOTE: The EXTENSION SLIDES (35MC) will be used later for the DRAWERS.
å
Fasten the CABINET RIGHT (40CA) to the UPRIGHT (C2) and CABINET LEFT (40CB)
å
to the LEFT END (B). Use four GOLD 5/16" FLAT HEAD SCREWS (3S) through holes
#1 and #3.
Push the black lever in and pull the SLIDE from the RAIL.
2
1
Roller end
Open end
Page 6
35MC
4
3
B
Roller end
1
2
3
4
C2
422811
Remember:
Righty tighty.
Lefty loosey.
35MA
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
www.sauder.com/services
3S
Open end
Publicidad
