Publicidad
Step 13
1
D107
Groove
Insert the DRAWER SIDES (D107 and D108) at an
å
angle into the slot at each end of the DRAWER FRONT (T).
3
Be sure the
DRAWER
BOTTOM inserts
into the DRAWER
BACK groove.
Fasten the DRAWER BACK (D109) to the DRAWER SIDES (D107 and D108). Use four BLACK 1-9/16" FLAT
å
HEAD SCREWS (30S).
NOTE: Be sure the LARGE DRAWER BOTTOM (D707) inserts into the groove of the DRAWER BACK (D109).
å
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D108
T
D107
D707
VIEW THE T-LOCK BOX VIDEO
2
D107
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the LARGE DRAWER BOTTOM (D707) into the grooves in
å
the DRAWER SIDES (D107 and D108) and DRAWER FRONT (T).
D109
D108
422811
With the palm of
your hand, tap
the DRAWER
U n
BOTTOM down
fi n
s u
i s h
into the groove.
r f a
e d
c e
D707
D108
T
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(4 used in this step)
Page 17
Publicidad
