Instructions for use
IMPORTANT: The Kudu comes with the wheels detached. Before unfolding the
pushchair for the first time, fit the wheels.
Fitting the rear wheels
•
Fit the rear wheels by pressing the central button (a) and inserting the axle into the hole
(b) of the rear wheel bearer (fig. 1). It will click when correctly in place. Check that the
wheel is secure and turns freely.
•
To detach the wheels, follow the same steps in reverse order.
Fitting the front wheels
•
Fit the wheel sets into the slots, pressing them upwards until they click into place (fig. 2).
•
To detach the wheels, turn the wheel set until you can see the release button (fig. 3).
•
Press the button and pull the wheel set until it comes free.
Unfolding
(illustrations 4-5)
•
Pull the handlebar and release the locking device, until the pushchair is completely unfolded.
Locking the front wheels
•
To stop the front wheels from swivelling, press the button between the two wheels
downwards. To unlock the wheels, press the button upwards.
Parking brake functioning
•
To put the brake on press the pedal on the rear right wheel downwards.
•
To take the brake off, push the pedal upwards.
Fitting the seat
•
Put the parking brake on.
•
Insert the connectors into the two slots of the side adaptors.
•
Make sure that both sides are securely fastened onto the pushchair. They will click
when correctly in place.
•
The child can now sit in the seat.
WARNING: Extract the Unisystem adaptors before installing the seat.
Fitting the armrest
•
Insert the ends of the armrest into the front slots of the pushchair (fig. 9).
•
To remove the armrest, press the buttons on the sides and pull the armrest upwards (fig. 10).
(illustration 1)
(illustrations 2-3)
(illustration 6)
(illustration 7)
(illustration 8)
(illustrations 9-10)
19