Connecting The Antenna Terminals - Marantz SR4320 Guia Del Usuario

CONNECTING THE ANTENNA TERMINALS

FM antenna
GND
PHONO CD
IN IN
L
R
Assembling the AM loop antenna
1 Release the vinyl tie and take out the connection line.
2 Bend the base part in the reverse direction.
3 Insert the hook at the bottom of the loop part into the slot at the
base part.
4 Place the antenna on stable surface.
FM external
antenna
ANTENNA
VIDEO
AM
DSS DVD VCR MONITOR
IN IN IN OUT OUT
GND
FM (75 Ω)
CDR / MD TAPE DSS DVD VCR PRE
IN OUT IN OUT IN IN IN OUT OUT
AUDIO
AM external
AM loop
antenna
antenna
REMOTE
CONTROL
IN
OUT
SPEAKER SYSTEMS
SYSTEM A : 4 -16 OHMS
SYSTEM B : 4 -16 OHMS
SYSTEM A+B : 8 -16 OHMS
SYSTEM B
R L
MAIN
IN
R L
SYSTEM A
Connecting the supplied antennas
Connecting the supplied FM antenna
The supplied FM antenna is for indoor use only.
During use, extend the antenna and move it in various directions until
the clearest signal is received.
Fix it with push pins or similar implements in the position that will cause
the least amount of distortion.
If you experience poor reception quality, an external antenna may
improve the quality.
Connecting an FM external antenna
Notes:
• Keep the antenna away from noise sources (neon signs, busy
roads, etc.).
• Do not put the antenna close to power lines. Keep it well away
from power lines, transformers, etc.
• To avoid the risk of lightning and electrical shock, grounding is
necessary.
Connecting an AM external antenna
An external antenna will be more effective if it is stretched horizontally
above a window or outside.
Notes:
• Do not remove the AM loop antenna.
• To avoid the risk of lightning and electrical shock, grounding is
necessary.
11
AC IN
SERIAL NO.