Listening To A Different Audio Source While Watching A Video Source; Changing The Brightness Of The Front Display; Setting The Sleep Timer; Recording Operation - Marantz SR4320 Guia Del Usuario

LISTENING TO A DIFFERENT AUDIO
SOURCE WHILE WATCHING A VIDEO
SOURCE
1 Select one of the following video sources.
DVD, DSS or VCR
2 Next, select one of the following audio sources with remote control
unit.
TUNER, PHONO, CD, TAPE or CDR/MD
CHANGING THE BRIGHTNESS OF THE
FRONT DISPLAY
The display brightness changes in three steps (max, min and off) by
pressing the DIMMER button on the remote control unit repeatedly.
During display off mode, the DISPLAY OFF indicator lights up.

SETTING THE SLEEP TIMER

Set the sleep timer while the power is turned on.
1 Turn the power ON and press the SLEEP button on the remote
control unit to enter the sleep timer mode.
2 Press the SLEEP button the number of times to set the desired
sleep time in minutes.
Each press of the SLEEP button, changes the display in the
following order.
10 20
OF (off) 90
The unit will be in the standby mode in the number of minutes
indicated.
• While the sleep timer is activated, the remaining time can be displayed
for approximately 2 seconds by pressing the SLEEP button.
• To cancel the sleep timer, press SLEEP button several times until
"SLEEP OF" (SLEEP OFF) appears on the display.
30 40 50
80 70 60

RECORDING OPERATION

1 Press the POWER button to turn on the power.
Press the function select button of the source you want to record
2
from.
3 Start playback (or select a broadcast station) on the source
component.
4 Start recording on the recording component. For instructions, refer
to the component's instructions.
Notes:
• When this unit is in the standby mode or turn off, you cannot record
between other components connected to this unit.
• The setting of BALANCE, BASS, TREBLE, VOLUME, MUTE does
not affect the recorded material.
• A given input source does not output on the same OUT channel
(For example, the signal input from VCR IN is not output on VCR
OUT).
• If you playback a video source that uses scrambled or encoded
signals to prevent it from being dubbed, the picture itself may be
disturbed due to those signals.
13