Configuration - Festo CPV GE-IB-8 Serie Breve Descripción

3

Configuration

Caution
The CPV direct contains electronically sensitive compo
nents. The CPV Direct will be damaged if you touch the
contact surfaces of the plug connectors and if you do
not observe the regulations for handling electrostati
cally sensitive components.
Proceed as follows when configuring:
1. Switch off the power supply.
2. Set the following with the DIL switches: extension to
the CP system, diagnostic mode, baud rate.
Warning
S Make sure that switch−on test pulses are sup
pressed/switched off when you operate the CPV
Direct via a safety I/O module".
S Check the measures required for putting your system
into a safe status in the event of an EMERGENCY
STOP.
Further information can be found in manual
P.BE−CP−IB−.. .
Festo CPV..−GE−IB−8 0503a English 17