Descargar Imprimir esta página

KTM 600.12.020.000 Instrucciones Para El Montaje página 4

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

3
1
1
2
3
4
Scope of supply
600.12.020.000
1 x trunk holder, right
600.12.020.060
1 x trunk holder, left
600.12.020.050
1 x connecting rod for trunk holder
2 x AH screw M8 x 70
2 x AH screw M6 x 20
4 x washer M6
2 x self-locking nut M6
2 x flat-head screw M8x60
2 x flat-head screw M8x70 (75)
4 x flat-head screw M8x30
Assembly
The assembly procedure is the same for the right and left side. It will be des-
cribed for the left side but the same procedure must be carried out on the
right side.
Partially screw in all of the screws. When all of the screws are partially scre-
wed in, tighten to the respective torque and secure with Loctite 243.
Unscrew the three fixing screws [1] on the retaining clip and remove toget-
her with the trunk lid rack.
Now remove the fixing screws from the rear footrest support [2].
Place the trunk holder on the mounting points for the retaining clips [3].
Place the trunk lid rack on the retaining clips and screw both to the vehicle
from above using the flat-head screws [4] included in the scope of supply.
600.12.020.100
600.12.020.160
600.12.020.150
600.12.020.070
600.12.020.080

Publicidad

loading

Este manual también es adecuado para:

600.12.020.100