Kobalt KCS 6524B-03 Manual Del Usuario página 15

OPERATING INSTRUCTIONS
9. Cross-Cutting/Rip Cutting
When making a cross-cut or a rip cut, align the
guideline with the 90˚ blade-guide notch (N) on the
base shoe (T). The distance from the saw blade to
the saw base is approximately 3-5/8 in. (9.2 cm) on
the left side of the saw and 1-1/2 in. (3.7 cm) on the
right side.
Blade thicknesses vary, so you should always
make a trial cut in scrap material along a guideline
to determine how much the guideline must be offset
from the guide to produce an accurate cut.
NOTICE: Use a guide when making long or wide
rip cuts.
10. Rip Cutting Using a Straight Edge
a. Secure the workpiece.
b. Clamp a straight edge to the workpiece using
C-clamps (not included).
NOTICE: Position the C-clamps so that they will not
interfere with the saw housing during the cut.
c. Press the lock-off button (B) and depress the
trigger switch (D) to start the saw.
d. Allow the blade (J) to reach full speed, then
guide the saw into the workpiece and make the
cut.
e. Saw along the straight edge to achieve a
straight rip cut.
f. Release the trigger switch and allow the blade
to come to a complete stop.
g. Lift the saw from the workpiece.
NOTICE: Do not bind the blade in the cut.
9
10
15
N