Operating Instructions; Instrument Description; Front Panel; Turning On - HT QuickLAN 6055 Manual De Instrucciones

4. OPERATING INSTRUCTIONS

4.1.

INSTRUMENT DESCRIPTION

4.1.1. Front panel

1
2
3
4
5
6
Fig. 2: Instrument description

4.1.2. Turning on

To turn on the instrument press
firmware release appears on the top right side. When "on" is displayed the instrument is
ready to start.

4.1.3. Selection of cable type

By pressing or
following difference: STP performs also tests on the shield (continuity and proper
connections) while UTP doesn't.
Consequently STP must be pressed for all shielded cables such as:
FTP (Foiled Twisted Pair cable)
-
STP (Shielded Twisted Pair cable)
-
- SSTP (Shielded/Shielded Twisted Pair cable)
- SFTP (Shielded/Foiled Twisted Pair cable)
NOTE: by default the selected cable is STP. Any time the instrument is turned off and on
such type of cable is automatically selected.
. For an instant all display segments light up, then the
it's possible to select the type of cable to be tested, with the
EN - 5
LEGEND:
1. Jack RJ45
2. LCD
7
3. UTP key
8 4. GO key
5. Arrow keys
6. POWER key
7. STP key
8. Remote units #1 ~ #2
QuickLAN 6055