Kohler K-3588 Guía De Instalación Y Cuidado página 13

Troubleshooting (cont.)
Symptoms Recommended Action
2. The fill valve A. Clean the seal located on the flush valve or
turns on/off by
itself without the
toilet being
flushed, or it
runs, allowing
water to enter
the tank.
B. Remove the tank from the bowl, then tighten
C. Replace the fill valve if the float on the fill
D. Adjust the tank water level if the water level
3. Long tank fill A. Fully open the water supply shut-off valve.
cycle.
B. Clean the valve inlet, head of the fill valve,
Noisy tank fill A. Partially close the water supply stop valve
4.
cycle.
B. Remove dirt or obstructions from the head of
Warranty
ONE-YEAR LIMITED WARRANTY
KOHLER plumbing products are warranted to be free of defects in
material and workmanship for one year from date of installation.
Kohler Co. will, at its election, repair, replace or make appropriate
adjustment where Kohler Co. inspection discloses any such defects
occurring in normal usage within one (1) year after installation. Kohler
Co. is not responsible for removal or installation costs. Use of in-tank
toilet cleaners will void the warranty.
To obtain warranty service contact Kohler Co. either through your
Dealer, Plumbing Contractor, Home Center or E-tailer, or by writing
Kohler Co., Attn.: Customer Care Center, 444 Highland Drive, Kohler,
Kohler Co.
replace the flush valve if the seal is
damaged.
the nut on the flush valve if the gasket on
the flush valve is leaking. Do not
overtighten. If leakage continues, replace the
flush valve.
valve sinks.
is too high.
or supply line. Flush the lines.
located inside the tank if the water pressure
to the toilet is too high. Check the toilet
performance following any such adjustment.
the fill valve. Flush the lines.
13 1095641-2-E