SATA AE1023H Manual Del Uso página 60

3.12 Rotate the rim driven by chuck clockwise, and mount the upper tire.
The most important thing is to check the tires and rims to prevent explosion during inflation. Before starting the installation operation,
ensure that: The tire and tire tread fiber are damaged. If so, do not install the tire; there are no dents and warpings on the rim upon visual
inspection, pay attention to there are no tiny scratches on the inner side of the aluminum alloy rim, which are dangerous, especially during
air inflation.
3.13 Lubricate the tire opening with special grease, so as to avoid damaging the tire opening and facilitate operation.
- When the rim is locked, do not put your hands under the tire. The correct operation is to position the tire in the center of the crankset
and make sure that no one is standing behind the column while the tire is tilted.
- If the size of the dismounted rim is the same, it is unnecessary to lock or unlock the tire dismounting arm frequently. All you need to do is
to tilt back or restore the column to the working position and keep the tire dismounting arm in the working position.
- Never put your hand above the tire. The return of the column to the working position will squeeze the operator's hand, so the column will
be clamped between the tire and rim.
3.14 Move the tire so that the tire opening passes under the front end of the birdhead, and the turnup of the tire opening is pushed
against the rear part of the birdhead to press the tire opening into the slot of the rim by hand. Step on the pedal to cause the crankset
to rotate clockwise. Continue this operation until the tire is fully loaded into the rim.
In order to prevent industrial accidents, keep hands and other parts of the body as far away as possible from the tire dismounting arm
when the crankset rotates.
3.15 Place the inner tube and repeat the above operations.
When dismounting and mounting tires, the crankset shall rotate clockwise. Counterclockwise rotation is only used for error correction
when the machine is shut down and causes the operator's error.
60
AE1023H/AE1023H-3
中文
EN DE RU KO PT JA ES