Braun cruZer body Serie Manual De Instrucciones página 8

How to use the cruZer body
Make sure that you always keep your skin stretched when shaving or
trimming.
The cruZer body is not intended for removing facial hair or scalp hair.
• Trimming («1»):
Trimming on the skin / contour trimming
For trimming precise lines and contours, just use the trimmer (2)
(picture a).
Press the on/off switch (6) to turn on the cruZer body.
Stretching your skin, carefully move the trimmer against the direction of
hair growth.
For this function, you can use Gillette shaving foam or gel.
Using the trimming combs (1a) – (1c)
For best results use the trimming combs on dry hair only. Do not use
shaving foam or gel for this application. Whenever hairs build up in front
of the comb, remove them.
Trimming on the skin in sensitive areas (e.g. genital area) with the
«sensitive» attachment (1a)
For trimming in sensitive areas and improved skin care, you should use
the «sensitive» attachment (1a) (picture b). Snap it onto the trimmer (2)
as shown until it clicks into place. Press the on/off switch (6) to turn on.
Gently move the cruZer body against the direction of hair growth with
the comb tips pointing forward. In sensitive areas take special care that
the skin is always stretched to avoid injuries.
Trimming the hair length with trimming combs «medium» and «long»
The trimming combs (1b) / (1c) allow you to cut the hair to 2 different
lengths («medium» = 3 mm or «long» = 8 mm).
Start with the «long» trimming comb (1c) to acquire practice. Gently
move the cruZer body against the direction of hair growth with the comb
tips pointing forward (picture c).
• Combishave («1+2»):
Trimming and shaving in one stroke for a close shave of long haired
sections with the trimmer (2) and shaving system (3)
The combishave is suitable for large areas like chest and back.
Press the « » button and extend the slider to the «1+2» setting
9