Cleaning And Maintenance - Braun cruZer body Serie Manual De Instrucciones

(picture d).
Press the on/off switch (6) to turn on the cruZer body. The trimmer first
raises all long hairs and cuts them off. The shaving system (3) follows to
smooth away any stubble.
For best results, always make sure that both, the trimmer and the
shaving system are in contact with the skin. When using this function,
we recommend using Gillette shaving foam or gel.
For sensitive areas, we recommend starting with the «sensitive»
attachment (1a) and then finish with the shaving system (3).
• Shave («2»):
For a close shave of stubbled areas with the shaving system (3)
Pressing the « » button, extend the slider (5) as far as it will go to
setting «2» (picture e).
Place the shaving system (3) on the stretched skin and gently move it
against the direction of hair growth.
Do not apply too much pressure and always keep your skin stretched.
Make sure the shaving system is in full contact with the skin.
When using the shaving system, we recommend using Gillette shaving
foam or gel.
Protection sleeve / holder for the shower
The cruZer body comes with a protective cover that can also be used as a
shower holder.
When used as a protective cover, insert the cruZer body with the trimmer
inside.
When using it as holder, insert the cruZer body with the trimmer outside
(see picture 9).

Cleaning and maintenance

After each use, clean the cruZer body.
Remove the trimming comb and brush it out.
You may also use the brush to clean the trimmer if it has been used for dry
applications only.
If you have used the cruZer body with shaving gel or foam, rinse it under hot,
running water as shown (in picture f). Shake well to remove excess water
and leave to dry.
Apply a drop of light machine oil onto the trimmer on a weekly basis.
10