RIDGID RT14000 Manual Del Usuario página 10

ASSEMBLY
Installing/Removing Cart Push
Handle
1. To Install Handle: Slide the Cart Push
Handle into the two Handle Holders
found on the rear of the Dust Drum.
2. Press down evenly on the Cart Push
Handle until both sides are fully seated
in the Handle Holders. The Release
Buttons should audibly snap into the
Locking Holes.
INSTALL:
3. To Remove Handle: Grasp both
sides of the Handle just above the
Handle Holders. Press in firmly on the
two Release Buttons using the index
fingers while pulling up on the Cart
Push Handle. It may help to place a
foot on one of the rear feet to secure
the Vac.
SP7080-1 RT14000 2019.indb 10
Cart Push Handle
Dust Drum
Release
Buttons (2)
Handle
Holders (2)
10
REMOVE:
Inserting/Removing the
Professional Locking Hose
1. To Insert Hose: Locate the end of the
Professional Locking Hoseand align it
with the Drum Inlet. Position the Hose
Release Button with the Ridges on the
Vac Inlet. Push the Hose end straight
into the Vac Inlet until the Hose Release
Button fully engages the Inlet Ridges.
Hose Release
Button
Professional Locking
Hose
Cart Push Handle
Release
Buttons (2)
Handle
Holders (2)
INSERT
HOSE
Drum
Inlet
Ridges
4/22/19 8:35 AM