Oki OKIPOS X400 Serie Guía De Installación página 12

The OKIPOS X400 thermal tran
label to produce an image.
1. L ift the top cover.
2. Press the two print head releases down to unlock the print head module
and expose the ribbon supply spindles.
3. Unwrap the new ribbon
ribbon is attached to
4. Observe the notches on both end o
These notches must
take-up spindles.
5. Roll several turns of ribbon on the take-up core. The coated side of the
ribbon must be on the outside of the take-up roll.
6 . Place the left notch of take-up core into the nib of left take-up spindle.
7. Place the right notch of take-up core into the nib of right take-up spindle.
8. Pull the ribbon on down the over the print head and insert the supply
onto the left supply spindle, making sure the notches in the core fit o
the nibs.
9 . Place the right end of the supply core into the right spindle, lining up the
notches with the spindle nibs.
Note:
Make sure the (coated) dull side of the ribbon is to the outside where it
will be in contact with the label media.
10. Turn the take-up spindle to pull the ribb
slack. Check
11. Lower the print head and press it firmly until it locks securely on both
sides.
8
sfer printer transfers ink from a ribbon to the
and unwind 4" from the roll. The end of the
a take-up core.
fit on the corresponding nibs on both the supply and
to ensure there are no ribbon wrinkles.
f the supply core and the take-up core.
on over the print head without any
core
ver