Positioning And Handling - MBM PRQ7 T Serie Manual De Uso E Instalación

SHING LIMBS / This risk exists
where there is accidental contact
between the parts during positio-
ning, transportation, storage and
assembly.
RESIDUAL
EXPLOSIONS / This risk re-
mains when:
• there is smell of gas in the room;
• appliance used in an atmosphe-
Before proceeding with the ope-
rations, see "General safety infor-
mation".
OBLIGATIONS - PROHIBITIONS -
ADVICE
Upon receipt, open the machine
packaging and ensure that the
machine and accessories have
not been damaged during transporta-
tion. Where this is found to be the case,
notify the carrier immediately and do
not proceed with installation but contact
the qualified and authorised personnel.
The manufacturer is not liable for dam-
age caused during transportation.
HANDLING SAFETY /
Failure to follow the instructions
reported below could result in
exposure to the risk of serious
injury.
The operator authorised for the
handling and installation opera-
tions of the appliance must pre-
pare, if necessary, a "safety plan" in or-
der to ensure the safety of the persons
involved in the operations. In addition,
they must follow and strictly and scrupu-
lously implement the laws and regula-
tions relating to mobile sites.
Ensure that the lifting means
adopted have capacity that is
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION
RISK OF

POSITIONING AND HANDLING

- 8 -
re containing substances which
risk exploding;
• using food in closed containers
(such as jars and cans), if they are
not suitable for the purpose.
RESIDUAL RISK OF FIRE /
This risk exists by flammable
liquids / material flammabl
adequate for the loads to be lifted and
are in a good state of maintenance.
Perform the handling operations
using lifting means with a capaci-
ty appropriate to the weight of
the appliance increased by 20%.
Follow the directions on the
packaging and/or on the same
appliance before handling.
Check the centre of gravity of the
load before lifting the appliance.
Lift the appliance to a minimum
height from the ground in order
to ensure its handling.
Do not stand or pass under the
appliance during lifting and han-
dling.
HANDLING - TRANSPORTATION
/ - see SECT. IMAGES - REF. a).
The orientation of the packed
appliance must be maintained
according to the instructions
given by the pictograms and lette-
ring on the outer packaging (detail
A).
Position the lifting means paying at-
1.
tention to the centre of gravity of the
load to be lifted (detail B-C).
e
3.