MBM PRQ7 T Serie Manual De Uso E Instalación página 37

3. Turn the knob to "Zero" (Fig. 1-2 C)
to stop heat generation.
The oven cooking temperature
is set by turning the thermostat
knob. (See indications on knob).
Hotplate heating speed is set by
turning the knob (Position 0-6).
Position 6 is the maximum hea-
ting speed.
Before using the oven for the first
time, it is advisable to pre-heat it
at the highest setting for 30-40 minutes
with the door closed. This burns any
oily residue that could release unplea-
sant odours.
LOADING / UNLOADING THE PRO-
DUCT / see SECT. IMAGES - REF. i)
When cooking has finished, switch the
appliance off. Turn the switch-on knob
to "Zero" (Fig. 9B).
The amount of the product insi-
de the container must not exce-
ed 3/4 its capacity.
1. Place the container in the middle of
the hotplate (Fig. 3).
When cooking is over, remove the con-
tainer from the hotplate and put it in a
place prepared beforehand.
2. Open the oven door to load it.
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
INSTRUCTIONS FOR USE
Put the container in the cooking com-
partment in the middle of the grid (Fig.
4). Close the oven door.
When opening the doors, step
to the side of the appliance to
avoid direct heat.
When the product is cooked, unload
it and put it in a place prepared befo-
rehand.
After the product has been unloaded,
load it once again or else perform the
operations described in "Deactivation".
DEACTIVATION / At the end of the
work cycle, turn the knobs on the ap-
pliance to "Zero".
The appliance must be cleaned
regularly and every incrustation
or food deposit removed. See
chapter: "Cleaning instructions".
If present, the indicator lights
must be off at the end of the
work cycle.
Check the cleanliness and hygiene of
the appliance. See "Maintenance".
Close the network locks upstream the
appliance (e.g. Gas - Water - Electric).
- 15 -
7.