Chapter 2 Operating Precautions And General Safety; Warnings; Electrical Safety - DePuy Synthes Purevue Manual De Instrucciones

Chapter 2
Operating Precautions and General Safety
Read and understand this manual before using the system.
The following list of warnings and precautions applies to the general
operation of the System.
2.1

Warnings

It is important to read this document completely prior to installation, setup, use, or post-use
activities . Throughout this document, the words "NOTE," "CAUTION," and "WARNING" have
special meaning .
NOTE:
Tips for optimal operation and other useful information
CAUTION! Failure to observe caution can result in damage to the device
WARNING! Failure to observe warning can result in injury to the patient or user

2.1.1 Electrical Safety

• Electrical safety testing should be performed by a biomedical engineer or other qualified
person .
• Risk of electrical shock . Do not remove the housing . Refer servicing to authorized Repair
Service Center .
• Do not connect the device to a power source that is not properly earthed (grounded) .
• Disconnect the device from the main power source when cleaning, servicing or inspecting .
• Inspect all equipment and cables periodically for wear . If damage is noted, replace or return to
Repair Service Center .
• Avoid fluid contact on the system and its electrical connectors .
• To avoid risk of fire, replace fuses with same type and rating .
• Do not restrict access to the power switch . Ensure that the Camera Control System is
positioned so that access to power main is not obstructed . To remove all mains power from the
unit, disconnect the power cord from the appliance inlet .
• The power supply detachable cord serves as the means of isolation between the power supply
and the power main . Ensure that the placement of the equipment does not interfere with
access to the power supply cord .
• Type BF . Conforms to standard IEC 60601-1 .
10